bobthebuilder
Well-Known Member
Hi guys,
The picture below illustrates the last station where the rudder post and stab spar are to be fitted.
I was thinking about cutting and notching the bottom longeron to accept the rudder post, and the last diagonal to accept the stab spar at this point.
Is it recommended to do it at this stage, or should I rather wait until after the two sides are jigged upside down on the table, joined and bent?
The picture below illustrates the last station where the rudder post and stab spar are to be fitted.
I was thinking about cutting and notching the bottom longeron to accept the rudder post, and the last diagonal to accept the stab spar at this point.
Is it recommended to do it at this stage, or should I rather wait until after the two sides are jigged upside down on the table, joined and bent?